Clutch info

[92RAGTOP]

Clutch & throwout bearing KAPUt in my 90. Does anyone have any input/advice as to who can do it at a fair price? How much should I expect (ballpark) ? Don

[Bill Burkholder]

Don ask Tony B. board member. I know that he did his own clutch but he may have an idea on cost. You could get an estimate from Bryner. Just tell them that your a club member... Bill

[Stephen DeFazio]

Rich Dunbar from our club has a trans shop im shore he can get it done at a good price.

[Tony B.96LT4]

Don, figure @$275-$300 for the pressure plate and throwout bearing. Clutch is another $150-$250 depending on where you get them. If your flywheel is shot that will jack up the price another $750-$800. Steve Spencer at Bryners told me about a hot set-up if you need the flywheel. F-body flywheel and pressure plate with the stock Vette clutch. He has done a couple of these and I'm going that route the next time I need a clutch. It will be a little noisier that stock but wont be as expensive. Price to install is going to be high cause it takes @ 8 hrs. Sean at the Vette Shop can also do it so you may want to check with him.