Hi guys and gals! Back and with some questions.

[IceDigger]

I have done a couple more mods to my 84 vette and am interested in getting a custom ECM done for my car. Do you have any suggestions as to where around the Warminster area that does that?

Also anybody willing to give a poor guy a free dyno run ticket? ;)

I'm dying to see how much hp/tq my car has. So far it has the following mods:

X-RAM, Flowmaster Exhaust, Gutted Cat, CAI, CS144 Alternator from stock, 85 Fuel pump, K&N Air Filter, 1.6rr, and a Hypertech Performance Chip

[Rick and Arleen Ball]

Bring it down to E-Town this year. Run it with the other Club members, that will give you an idea how your mods worked out.

[Bill Burkholder]

Go to JD's in H.V. ;bt

[Tony B.96LT4]

I'm with Bill on going ot JD's. Brian can whip up some ponies for you. How's the XRam running?

[IceDigger]

X-RAM is running fine. Got a squeaky fan belt I have to replace though. Only problem with her now.

[IceDigger]

JD's? Where is that located in Huntington Valley?

If he can make a new chip for me then I'm game. Probably in a month or 2.

[Tony B.96LT4]

Mike Campbell had this info in another thread:

Bryan Herter does programming etc. for JD's. You can check out his web page at PCMforless.com.

His phone number is 610-685-8871

Just went to his web site. He doesn't list the '84 but it still is worth a shot to give him a call.

[Joel Fellman]

JD's is located at 810 Welsh Rd. right off Huntingdon Pike Rt. 232- 938-9270. The owner, Joe Dutkiewicz, is a good guy, they do great work & he's a fellow member in the NE Muscle Car Club! Plus he advertises in our Gas Cap!
If you go, say hi to Joe for me!
Joel

[IceDigger]

He doesnt support my year he says :(

Any other options guys?