Splash guards

[moose13]

Any recommendations on the clip-on or bolt-on type. I'm leary about needing to drill hoes, but the bolt-on type seem to look better. Does anyone have any pics?

Thanks

[Glennm27]

Any recommendations on the clip-on or bolt-on type. I'm leary about needing to drill hoes, but the bolt-on type seem to look better. Does anyone have any pics?

Thanks

You can have the C6 Z06 gaurds installed on your C6 with very slight modifications. I saw a C5 that ECS had put the C6 Z06 gaurds on and it looked great..

I'll try to get a picture of THAT car for you and post here. IF they went on the C5 as well as these did, they could go onto your car even easier.

ALSO, did you happen to notice the guards Mark has on his C6?? They are pretty nice too.. He'll read this sometime and chime in I'm sure....

[Glennm27]

This is the C6 Z06 rear gaurds altered by ECS to fit the C5

http://temp.corvetteforum.net/members/tempsites/boptician//p1010025.jpg

They look terrific on the C6's

[Stone Crusher]

I have the screw-on type, they do a great job of keeping the road junk off the side of car. Can e-mail you some pic if you like.

[jacques]

I have the type that attach to the front using the existing push pins and attach to the back with clips. No holes and works great. I got them from Mid America, but Pipedreams on the Corvette Forum sells the same product. This is the MAM link

http://www.madvet.com/shop?frame=7.305.6776

Jacques

[Mike Campbell]

Ah ha !! But do they keep spin off from DR's ??? ;tt
They do look good.:D

[Norm Clemmer]

This is the C6 Z06 rear gaurds altered by ECS to fit the C5

http://temp.corvetteforum.net/members/tempsites/boptician//p1010025.jpg

They look terrific on the C6's

Who is ECS? I didn't think East Coast Superchargers was selling them. I think it is a great paint saving idea and would like to buy them.
Norm

[Bill Burkholder]

NORM......
Here are the PDF's
http://www.nitekrazze.com/images/Corvette/C6Fender/



I'm going to order them from Bryner and make it a winter project. I like the looks and protection. I now run 305's on the rear so I think that it will look ok. Bill

[Glennm27]

Who is ECS? I didn't think East Coast Superchargers was selling them. I think it is a great paint saving idea and would like to buy them.
Norm

East Coast Supercharging did that to Barry's car.. That's the pewter coupe in the picture...

[Stone Crusher]

NORM......
http://forums.corvetteforum.com/show....php?t=1414932 (http://forums.corvetteforum.com/show....php?t=1414932)

I'm going to order them from Bryner and make it a winter project. I like the looks and protection. I now run 305's on the rear so I think that it will look ok. Bill

Bill, that link is not working, do you have a part number for these.

Bud



PS Ok, found it, Thanks!!

[Glennm27]

Bill, that link is not working, do you have a part number for these.

Bud

Mudguards are 15818636 and 15818637.
Retainers are 11519444 and they come 10 to a pack.